Fault codes vary by manufacturer and control system; there is no industry-wide unified code. Any so-called "complete list" must be verified against your machine's manual. Generic categories: VFD (over-current, over-voltage, over-temperature, encoder error), temperature (thermocouple break, over-temperature, heating circuit fault), drive (tension deviation, limit switch, emergency stop), and pneumatic/hydraulic (low pressure, valve not at position). Response order: record the code and machine state (which zone, what condition triggered it), look up the manual entry, then do three self-checks — power and grounding, sensor wiring, and mechanical jam. The same code can have different causes under different loads; do not replace parts based on code alone.
How Runda handles this
Specific codes follow the delivered manual — we do not fabricate a universal list. On delivery we provide two things: the machine's own code table and a three-item pre-check list (power/ground, sensor wiring, mechanical jam).
Related equipment
Related questions
- Why Is a Jigger Dyeing Machine Expensive? Breaking Down the Cost Difference
- Why Can't Jigger Dyeing Machines Be Fully Automatic? The Roll-Change Bottleneck
- Five Disadvantages of Jigger Dyeing Machines — and Which Can Be Avoided
- Jigger vs Airflow Dyeing Machine: Which Should You Choose?
- Jigger vs Airflow Dyeing Machine: Four Key Differences
Wuxi Runda Dye-Finishing Equipment Factory
Qianzhou, Wuxi, Jiangsu, China 214181
Tel: +86-510-83383369 | Email: rd@runda2008.com | www.runda2008.com
Established 2004 | USCC 913202067573212793
