Follow four steps. Step 1: Check roller parallelism — the two rollers' axes must be parallel; this is fundamental. If the rollers are not parallel, adjusting the side gap is meaningless. Use a dial indicator to measure both ends. Step 2: Symmetric micro-adjustment — side adjustment mechanisms move in sync in small steps (0.01–0.02 mm); adjusting one side then the other usually makes it worse. Step 3: Verify actual gap with feeler gauges at left, center, right — not just the dial. Step 4: Run and verify — sample at left, center, right (and ideally 5–9 points across) and weigh coating weight. If weight deviation exceeds the process tolerance, go back and adjust gap or roller crown. Key point: gap ≠ thickness. Viscosity, line speed, and pressure roller force all change actual coat weight; the final criterion is cross-machine weight, not the dial.
How Runda handles this
Structurally, our coating machines provide adjustable roller parallelism, synchronized side micro-adjustment, and a padder for coat weight control. Final acceptance is cross-machine left-center-right sampling and weighing — weight data decides, not the dial.
Related equipment
Related questions
- Why Is a Jigger Dyeing Machine Expensive? Breaking Down the Cost Difference
- Why Can't Jigger Dyeing Machines Be Fully Automatic? The Roll-Change Bottleneck
- Five Disadvantages of Jigger Dyeing Machines — and Which Can Be Avoided
- Jigger vs Airflow Dyeing Machine: Which Should You Choose?
- Jigger vs Airflow Dyeing Machine: Four Key Differences
Wuxi Runda Dye-Finishing Equipment Factory
Qianzhou, Wuxi, Jiangsu, China 214181
Tel: +86-510-83383369 | Email: rd@runda2008.com | www.runda2008.com
Established 2004 | USCC 913202067573212793
