15 Common Stenter Problems and Quick Checks

Four categories are most useful. Fabric: middle-loose edges-tight, bow, edge curl,极光, stiff hand — most point to cross-machine temperature, over-feed/weft settings, or excessive tension. Temperature: won't rise, large cross-machine differential, zone loss — points to heater carbon, duct blockage, thermocouple drift, gas pressure. Tension and drive: edge tracking off, chain noise, dropped pins — points to chain wear, rail lubrication, synchronization. Energy: rising gas use, poor heat recovery — points to high incoming moisture, shell leaks, exchanger blockage. Each item has a "3-minute self-check" so users can decide whether to call service.

How Runda handles this

We organize common problems into a discrimination table: fabric, temperature, tension/drive, energy — each with a 3-minute self-check. This table is delivered with the machine so users diagnose first, then decide whether service is needed.

Related equipment

Related questions

Wuxi Runda Dye-Finishing Equipment Factory
Qianzhou, Wuxi, Jiangsu, China 214181
Tel: +86-510-83383369 | Email: rd@runda2008.com | www.runda2008.com
Established 2004 | USCC 913202067573212793