Calculate three ledgers first: heat consumption (heating and water evaporation), electricity (fans and drive), and wasted loss (shell radiation, heat carried out in exhaust, over-drying). Three corresponding measures: (1) Exhaust heat recovery — preheat fresh air with exhaust heat; good recovery saves 10–20% fuel. (2) Oven insulation and seals — door gaskets, shell gaps, duct insulation; low cost, fast payback. (3) Process side — control incoming moisture (poor upstream hydroextraction means extra steam in stenter), reasonable over-feed and line speed, and set temperature by fabric rather than always running high. Together these usually save 20%+. Note: replacing equipment without these three steps will not significantly reduce energy.
How Runda handles this
Our energy-saving package covers all three: exhaust heat recovery, shell insulation and door seals, and moisture/process parameter management. Replacing equipment alone without these three will not reduce energy — we tell you this upfront.
Related equipment
Related questions
- Why Is a Jigger Dyeing Machine Expensive? Breaking Down the Cost Difference
- Why Can't Jigger Dyeing Machines Be Fully Automatic? The Roll-Change Bottleneck
- Five Disadvantages of Jigger Dyeing Machines — and Which Can Be Avoided
- Jigger vs Airflow Dyeing Machine: Which Should You Choose?
- Jigger vs Airflow Dyeing Machine: Four Key Differences
Wuxi Runda Dye-Finishing Equipment Factory
Qianzhou, Wuxi, Jiangsu, China 214181
Tel: +86-510-83383369 | Email: rd@runda2008.com | www.runda2008.com
Established 2004 | USCC 913202067573212793
