Three judgment points. (1) Recovery form: gas-gas heat exchange (plate or heat pipe) is most common, for preheating fresh air; gas-water can produce hot water for reuse. Choice depends on exhaust oil/lint content — stenter exhaust carries oil mist, so plate exchangers clog easily; heat pipe or self-cleaning designs are more durable. (2) Recovery efficiency: require measured recovery rate and pressure drop; below 15% recovery the payback is too long — not recommended. (3) Maintenance cost: can it be cleaned online, is filtration fitted? Blockage raises fan energy and eats the savings. Practical advice: first measure exhaust temperature and airflow, calculate recoverable heat, then compare investment to payback (typically within 2 years to be worth it), and require a cleaning and maintenance plan from the supplier.
How Runda handles this
We select heat recovery based on exhaust oil/lint: stenter exhaust carries oil mist, so we prioritize heat-pipe or self-cleaning designs over plate (which clogs). We provide recovery rate, pressure drop, and cleaning plan; projects below 15% recovery we advise against.
Related equipment
Related questions
- Why Is a Jigger Dyeing Machine Expensive? Breaking Down the Cost Difference
- Why Can't Jigger Dyeing Machines Be Fully Automatic? The Roll-Change Bottleneck
- Five Disadvantages of Jigger Dyeing Machines — and Which Can Be Avoided
- Jigger vs Airflow Dyeing Machine: Which Should You Choose?
- Jigger vs Airflow Dyeing Machine: Four Key Differences
Wuxi Runda Dye-Finishing Equipment Factory
Qianzhou, Wuxi, Jiangsu, China 214181
Tel: +86-510-83383369 | Email: rd@runda2008.com | www.runda2008.com
Established 2004 | USCC 913202067573212793
