Electricity comes mainly from circulation fans, exhaust fans, and drive — estimate by installed power × load factor. Fans are rarely fully loaded; actual load is 60–80%. Heat is the big cost: estimate by hourly evaporated water × latent heat / thermal efficiency, which varies widely with fabric, moisture, and line speed. So looking only at "kWh per hour" is misleading — a machine may have low electricity but enormous heat cost. Correct estimation order: first measure incoming moisture and line speed, calculate hourly evaporation, then effective heat and actual heat consumption, then cost. Use plant-measured data (gas meter, electric meter, steam flow) — not brochure numbers.
How Runda handles this
Electricity is estimated by installed power × load factor, but heat is the big cost. On delivery we provide an energy log to fill from your electric meter, gas meter, and steam flow — not brochure numbers.
Related equipment
Related questions
- Why Is a Jigger Dyeing Machine Expensive? Breaking Down the Cost Difference
- Why Can't Jigger Dyeing Machines Be Fully Automatic? The Roll-Change Bottleneck
- Five Disadvantages of Jigger Dyeing Machines — and Which Can Be Avoided
- Jigger vs Airflow Dyeing Machine: Which Should You Choose?
- Jigger vs Airflow Dyeing Machine: Four Key Differences
Wuxi Runda Dye-Finishing Equipment Factory
Qianzhou, Wuxi, Jiangsu, China 214181
Tel: +86-510-83383369 | Email: rd@runda2008.com | www.runda2008.com
Established 2004 | USCC 913202067573212793
