Stenter Temperature Not Rising: Troubleshooting Guide

Troubleshoot four chains: heat source supply (low gas pressure, burner not fully open, thermal oil too cool, or circulation pump failure); heat exchange (heater fins carboned and linted — heat transfer drops sharply; this is the most common cause and clearing carbon usually restores it immediately); air circulation (fan belt slipping, insufficient airflow, duct short-circuit); temperature measurement (thermocouple drift or displacement causing false low reading, or the reverse). Start by measuring actual fabric-surface temperature to distinguish "really cold" from "falsely cold," then decide whether to check the heat source or the instruments.

How Runda handles this

When temperature won't rise, we first have you measure actual fabric-surface temperature to distinguish real from false cold. Heater fin carbon is the #1 cause; our manual gives recommended cleaning intervals and reminds you to clean exhaust filters at the same time.

Related equipment

Related questions

Wuxi Runda Dye-Finishing Equipment Factory
Qianzhou, Wuxi, Jiangsu, China 214181
Tel: +86-510-83383369 | Email: rd@runda2008.com | www.runda2008.com
Established 2004 | USCC 913202067573212793